top of page

Robotic Hydro Demolition: How It Works and When to Use It

Oct 27
2 min read

Updated: 7 days ago

Robotic hydro demolition has changed how concrete is removed on bridges, car parks, wharves and industrial sites. Instead of crews on jackhammers, a remote-controlled machine removes concrete with ultra-high-pressure water, to a set depth, while the operator stands well clear. Here's how it works and when it's the right tool for the job.

Conjet robot carrying out robotic hydro demolition on a concrete deck

How it works

The robot carries a lance that directs a jet of water at ultra-high pressure onto the concrete. The lance moves across the surface in a programmed pattern while the machine steps forward. The operator controls it remotely from outside the exclusion zone.

The water jet breaks up the concrete and washes it away. Because deteriorated concrete is weaker than sound concrete, the jet removes the damaged material first. By adjusting pressure, flow, nozzle and travel speed, the crew sets how deep it cuts and holds that depth across the whole area.

Why use a robot instead of jackhammers?

  • Consistent depth: the machine removes concrete to the same depth across the whole area, so only what the engineer specifies comes out.

  • Rebar left intact: the water removes concrete from around and behind the reinforcing steel without cutting or bending it, and cleans the bars at the same time.

  • No micro-cracking: the concrete left behind isn't damaged by impact, so repairs bond better and last longer.

  • Safer for crews: the operator works remotely, away from the jet, and nobody is exposed to jackhammer vibration or as much silica dust.

  • Speed on large areas: on decks, slabs and walls, a robot covers far more ground per shift than a team with breakers.

Hydro demolition robot set up at Brisbane Metro

Robotic or handheld?

Most jobs use both. The robot handles large, open areas where speed and consistent depth matter. Handheld lances, operated by trained crews, handle edges, corners, tight access, around penetrations and detailed work the machine can't reach. Planning which areas suit each is part of setting up the job.

Where robotic hydro demolition is used

  • Bridge decks, beams and piers

  • Car park slabs and ramps

  • Wharves and marine structures

  • Culverts, channels and spillways

  • Substations and industrial footings

  • Walls and soffits, depending on the equipment

What to plan for on site

  1. Access: the machine and its power pack need a route onto the work area, and sometimes a crane lift onto upper levels.

  2. Water supply: hydro demolition uses a steady supply of clean water.

  3. Water and slurry management: run-off contains concrete fines and needs capturing, settling and treating before disposal.

  4. Exclusion zones: the area around the jet is closed to other trades while the machine runs.

  5. Noise: the process is loud, so plan working hours with neighbours and occupants in mind.

  6. A trial area: a small test section confirms the settings give the specified depth before full production starts.

Talk to us early

Bringing a hydro demolition contractor in at the planning stage helps get access, water and staging right, which keeps the program on track. Water Jetting Solutions runs robotic and handheld hydro demolition crews across NSW, Victoria and Queensland and travels Australia-wide for larger projects.

See our robotic hydro demolition service, or call 0499 590 471 to talk through your project.

Planning a job that needs both robotic and handheld work? See our hydro demolition services for how we scope and run projects across NSW, QLD and VIC.

 
 
 
bottom of page